BOLT CALCULATOR: TYPE 11

This interactive tool is intended for the design of Type 11 bolted connections based on CSA O86:24 Clause 12.4.

This tool is intended for use by builders/designers who are experienced and familiar with bolt design calculations.

Main member and side member illustrated

STEP 1: BOLT CHARACTERISTICS

BOLT DIAMETER

SIDE MEMBER

MAIN MEMBER

ADJUSTMENTS

  • KT is applied to the modes related to wood member resistance (Row Shear, Group Tear-Out, Net Tension), while KTC is applied to the yielding modes which represent the interaction between the bolt and wood member. See CSA O86:24 for treatment factor requirements.

Correct sign

Step 1 is all good! Move on to the next step.

STEP 2: DIMENSIONS

MEMBER DIMENSIONS

  • The resistance of steel plate(s) needs to be checked separately.

  • Based on the selected dimensions, Member 1 uses a Light Framing grade.

  • Based on the selected dimensions, Member 1 uses a Beams and Stringers grade.

  • Based on the selected dimensions, Member 1 uses a Posts and Timbers grade.

  • Based on the selected dimensions, Member 2 uses a Light Framing grade.

  • Based on the selected dimensions, Member 2 uses a Beams and Stringers grade.

  • Based on the selected dimensions, Member 2 uses a Posts and Timbers grade.

BOLT SPACING

  • The following dimensions are set as minimum, but you can change them as you see fit.

Picture of dimensions illustrated
Your browser does not support the HTML canvas tag.

Show reference picture

A parameter has changed. Please re-submit to update governing resistance.

STEP 3: OUTPUTS

  • An error occurred when generating the output. Please check your internet connection and try again.

  • We generated the result based on your selection.

Non-governing resistances and corresponding failure modes:

Non-governing resistances not found.